Under-Body.

I restarted the paint stripping of the under-body. I used a grinder and a metal brush. I use my new 3M respirator and i am very happy with it. I’ll repeat: buy an expensive respirator unless you have spare lungs. The epoxy primer spills like chalk. Today i decided to…

Read more

This week the temperatures will be 10 to 13 degrees. With a little help from the heater in the garage it will be 16 °C which is the requirement for minimal temperature. The under-body is stripped to bare metal, and net treated with: Gas Grinder with metal brush Drill with…

Read more

Back

I continue with paint stripping of the metal part of the body. The under-body i stripped to bare metal, but then i realize that i am stupid – the original primer is very good. This is why i strip the rest to primer. Paint Stripping Under the dashboard i will…

Read more

Under-body

Paint Stripping I continue the paint stripping of the under-body of the car. I use a saw of electric cutting machine (see the end of this post) to remove the top layer of the factory conservation without a heat, i.e., i am scratching it out. The tracks are visible. These…

Read more

Paint Stripping

I said “welding is over”, but i remembered that there are 3 more points: The skeleton of the hood The right door The reinforcement Paint Stripping I started the preparation of the under-body. Strip to bare metal will be followed by zinc primer and urethane paint. I started removing the…

Read more

5/5