Left shock dome, bottom

Today i made the final cuts on the right side. Next i need to buy a MIG welder and let the fun start. God bless our deeds.

Cutting the point welding is not so easy as it look at first glance. The points don’t show where they are. The sheet steel is 1 mm thick and the grinder can’t go everywhere. Dremel helps a lot in this situation. Point by point the door panel goes out too.…

Read more

…and cut the body. There was a hit on the left side and it is visible where the hammer danced. Parts 1, 2 and 3 are ordered and will be replaced. The left part of the cross beam (antler) was hit and rotten. I will cut ~30 cm and rebuild…

Read more

3/3